Installing your Nerf Blazing Bow Adapter is very easy!

This device is created to prevent any type of hard modifications, no need to take the blaster apart.  It will have a very snug fitting to allow that nice bang on the Darts inserted once installed.  The tight fit also prevents the adapter from falling off during usage and possibly breaking.

HEre we will cover both methods for installing. The first is slightly more difficult.

1st method is the obvious, simply add the adapter and twist your hand back and forth while pulling the barrel down to the nerf bow. This is a bit tough, but will work.

If this method is too tough, the easy route will be to use a heat gun or hair dryer. Simply heat the outer adapter and the inner adapter slightly to soften the part. Please be careful not to heat too much or the device WILL loose its shape and render useless. Heat only enough to slightly soften and slide it on to the nerf bow. IT should slide on like butter and re-shape exactly to your barrel.  

If you are having issues with your SSWI 3D Printed SledgeFire Shells, you came to the right place.

On some occasions we will here of customers who cannot close the blaster once the shell is inserted.  Please remember the design of the shell is actually a few mm larger than the original shells.  This allows that extra performance boost once loaded and ready for use.

You will need to do a hard close to utilize properly.  This will not damage the shells or the blaster.  Please follow the below video demonstration once shell is inserted and locked in to place.

If you are having issues with the darts misfiring or not firing at all – make sure you are using clean / non-damaged darts.

Also if you have the SSWI 3 Shot Shell, you will need a Dart in each shell slot for proper use.  Inserting less than the required 3 will cause misfire issues.